Mercedes-Benz Sprinter: Reset Oil Light

Learn how to reset the oil change light in the Mercedes-Benz Sprinter by following one of the uniformed options below.

*TIP: After each oil change and new filter, the maintenance oil light indicator should disappear automatically. However, if it does not, it will need resetting for effective performance. Additionally, this indicator is included to alert you if there is a problem with the vehicle’s oil and is NOT to be ignored! If the warning is not addressed, this can lead to other unexpected costly engine issues. 

 **NOTE: If you are unable to reset the oil change notification light on the first try, REPEAT the steps. If you are still unsuccessful, contact the dealership for assistance or consult your vehicle user’s manual. 

OPTION 1

 

1. Turn the key to the ON position. DO NOT start the ignition.
   • Wait until you see the total mileage on the display screen before proceeding.
2. Press and HOLD the O button located in the RIGHT bottom corner of the Dash Screen/Instrument Cluster for about Thirty Seconds until you hear a BEEP.
3. Press the M button until you see either rESET .31 or rESET .51 (See image below) 
   • Or for older models, you may see rESEt 229.5 or rESEt 229.3 on your display screen.
     
4. PRESS and HOLD the O button again until you see the number TWO. Once this number pops up, you can Release the button.                                           
5. Next, press the O button TWO more times and the display screen should say either display reset done or rESET donE.
6. To verify if your Warning Indicator has been reset, completely turn off your vehicle and then restart the ignition. 

The warning light should be OFF!

---

OPTION 2: For Models With Steering Wheel Controls

 

1. Turn the key to the ON position. DO NOT start the ignition.
2. Wait until you see the total mileage on the display screen before proceeding. 
   • If the mileage does not show up, press the UP Arrow on the LEFT side of your steering wheel until the mileage is visible.
3. Continue to press the UP arrow until you see Service A Overdue By xxxx miles / Service A in xxxx Miles or Service B Overdue By xxxx miles / Service B in xxxx miles on the display screen.
4. Press and HOLD the O button (See First Image) for about 30 Seconds until you hear a BEEP.
5. Press the MENU button on the steering wheel.
   
6. Now press the UP arrow on the steering wheel once more until you see Service A overdue by xxxx miles / Service A in xxxx miles or Service B overdue by xxxx miles / Service B in xxxx miles on the display screen again.
7. Press the O button again.
8. Press the UP arrow until you see a message which says CONFIRM COMPLETE SERVICE.
9. Press and HOLD the O button for about THREE Seconds to set. You will then see SERVICE CONFIRMED on the screen. 

The Warning Light Should Disappear!