How to Turn Off the VSC Light in a BMW 3 Series

Are you tired of the VSC light constantly shining on your dashboard? Well, you’re in luck because turning it off is easier than you might think. In this article, we’ll give you a step-by-step guide on how to do it yourself. So sit back, grab a cup of coffee, and let’s get started!

2011 – 2023 Models

1. Begin with the engine turned off.
2. Purchase or borrow an OBD-II scanner.
3. Locate the OBD-II port under the dashboard, near the steering column.
4. Plug in an OBD-II scanner and turn on your car’s ignition (don’t start the engine).
5. Follow the scanner’s instructions to scan for error codes.
6. Clear error codes related to the VSC system.
7. Turn off the ignition and unplug the scanner.
8. Restart your BMW to check if the VSC light is off.

1990 – 1996 & 2004 – 2010 Models

1. Park your BMW and turn off the engine.
2. Open the hood and disconnect the negative (-) terminal of the car battery.
3. Wait for about 15 minutes.
4. Reconnect the negative terminal and start your BMW.
5. Drive the car and confirm the VSC light has turned off.

1997 – 2003 Models

1. Park your BMW and switch off the engine.
2. Locate the fuse box, usually in the engine compartment.
3. Remove the cover and find the fuse labeled “VSC” or “ESP.”
4. Use the fuse puller (often located inside the fuse box cover) to remove the fuse.
5. Wait for a minute, then reinsert the fuse.
6. Start your BMW and observe if the VSC light is no longer illuminated.