Dodge Ram: How to Reset Stereo System

Almost every Dodge Ram owner uses the stereo system daily. Below are directions for resetting the stereo system of a Dodge Ram.

Note: Doing this will erase any saved radio stations or paired phones. You will need to reset the stations and pair phones again when starting the car.

If neither of these options fixes the issue, please take your car to a certified mechanic or dealership.

2020 – 2023 Models

Fuses

  1. Open the driver’s side door. The fuse box is located under the steering wheel.
  2. Remove the screws from the lower portion of the cover.
  3. Pull the lid off.
  4. Check fuse F44.
  5. If the fuses are burnt, replace them with new ones.
  6. Replace lid and screws when finished.

2019 Models

Fuses

  1. Open the hood. The fuse box is on the right side of the engine compartment next to the battery.
  2. Press the tabs on either side of the lid and pull up.
  3. Check fuse F44.
  4. If the fuses are burnt, replace them with new ones.
  5. Replace the lid when finished.

2013 – 2018 Models

Fuses

  1. Open the hood. The fuse box is on the right side of the engine compartment next to the battery.
  2. Press the tabs on either side of the lid and pull up.
  3. Check fuse F55.
  4. If the fuses are burnt, replace them with new ones.
  5. Replace the lid when finished.

2011 – 2012 Models

Fuses

  1. Open the hood. The fuse box is on the right side of the engine compartment next to the battery.
  2. Press the tabs on either side of the lid and pull up.
  3. Check fuse M12.
  4. If the fuses are burnt, replace them with new ones.
  5. Replace the lid when finished.

2009 – 2010 Models

Fuses

  1. Open the hood. The fuse box is on the right side of the engine compartment next to the battery.
  2. Press the tabs on either side of the lid and pull up.
  3. Check fuse M39.
  4. If the fuses are burnt, replace them with new ones.
  5. Replace the lid when finished.

2006 – 2008 Models

Fuses

  1. Open the hood. The fuse box is on the right side of the engine compartment next to the battery.
  2. Press the tabs on either side of the lid and pull up.
  3. Check fuse 11.
  4. If the fuses are burnt, replace them with new ones.
  5. Replace the lid when finished.

Hard Reset for All Models

  1. Open the hood of the vehicle.
  2. Disconnect the negative battery cable from the terminal with a socket wrench. Make sure the cable is not touching the battery or terminal.
  3. Disconnect the positive terminal. Do not let it touch the terminal.
  4. Let the car sit for 3-5 minutes.
  5. Connect the cables to the battery again.

Leave a Comment